Maintenance Tech II

Essential Duties & Responsibilities

Installs, maintains, tests, troubleshoots and repairs in the areas of industrial machinery/equipment servicing, mechanical, electrical, plumbing, and vehicle servicing; is knowledgeable in the procedures and safety measures in these areas. Requires 2-5 years of experience in the industrial manufacturing field or in a related area. Familiar with standard concepts, practices, and procedures within the maintenance field. Relies on experience and judgment to plan and accomplish goals. Performs a variety of tasks. A certain degree of creativity and latitude is required. Works under limited supervision.

 

Experience, Skills & Education

· Strong Mechanically ability required

· Intermediate to advance Electrical Knowledge

· Safety Practices 

· Electrical (110v-480v AC, 24vDC, Control systems, Motor controls, etc.)

· Preventative Maintenance (Performing routine maintenance on machinery/equipment and determining when and what kind of maintenance is needed)

· Repairing Industrial machinery/equipment (Repair machines or systems with proper tools, parts, and safety practices)

· Plumbing (Including but not limited to gas lines, water lines, air lines, etc.)

· Fabrication (Designing, welding, brazing, etc.)

· Troubleshooting (Determining causes of operating errors and finding the correct solution)

· Use of hand tools

· Operate power tools

· Able to be forklift certified

· Able to work as part of a team

· Able to work independently

· Able to do precise and detailed work

·  Able to Read and understand blue prints, electrical schematics, technical drawings

· Good communication skills

· Keep records of work preformed

 

 

 

Additional Responsibilities

· Clean equipment or machinery.

· Clean, lubricate and adjust parts, equipment and machinery.

· Disassemble machinery and equipment to remove parts and make necessary repairs.

· Repair and replace broken or malfunctioning components of machinery and equipment.

· Make adjustments and repairs to heating, cooling, ventilating, plumbing, and electrical systems.

· Notify Managers/Supervisors concerning the need for major repairs on machinery and equipment.

· Preventative maintenance on machinery and equipment

· Analyze test results, machine error messages, and information obtained from operators in order to diagnose equipment failures.Install, align, assemble or dismantle, clean, lubricate, move, troubleshoot, inspect, examine, maintain, adjust and repair or replace defective parts of power transmission, hydraulic, electrical and pneumatic systems. Operate hoisting and lifting devices such as cranes, jacks and forklifts to position machinery and parts during the installation, set-up and repair of machinery Operate machine tools such as lathes and grinders to fabricate parts required during overhaul, maintenance or set-up of machinery Adhere to safety procedures Adjust or set mechanical controls or components Adjust production equipment/machinery setup Align or adjust clearances of mechanical components or parts Analyze operation of malfunctioning electrical or electronic equipment Assemble and install pipe sections, fittings, or plumbing fixtures Assemble, dismantle, or reassemble equipment or machinery Bend tubing or conduit Calibrate or adjust electronic equipment or instruments to specification Conduct performance testing Conduct tests to locate mechanical system malfunction Control HVAC equipment Coordinate production maintenance activities Cut, bend, or thread pipe for gas, air, hydraulic, or water lines Diagnose mechanical problems in machinery or equipment Inspect machinery or equipment to determine adjustments or repairs needed Install electrical conduit or tubing Install electrical fixtures or components Install/connect electrical equipment to power circuit lubricate machinery, equipment, or parts Maintain or repair industrial or related equipment/machinery Observe or listen to machinery or equipment operation to detect malfunctions Repair or replace electrical wiring, circuits, fixtures, or equipment Repair or replace malfunctioning or worn mechanical components Test electrical/electronic wiring, equipment, systems or fixtures Test electronic or electrical circuit connections